Vigor3900 v1.4.1 Release

版主: david

Vigor3900 v1.4.1 Release

文章門神 » 週一 10月 1日, 2018年 4:39 pm

Release Note for Vigor3900 Series
Firmware Version:
Release Type:
Applied Models:
Due to the firmware size limitation, for devices us
ing firmware version 1.0.5 or earlier, it is
suggested to upgrade to firmware version firs
t before upgrading to version 1.0.8.x and later.
New Features

Support VigorSwitch P2280/G2280 to be mana
ged under Central Management>>Switch.

Corrected: Unable to restore backup
configuration file taken by VigorACS.

Corrected: SNMP service stopped working for
a period of time and recovered again.

Corrected: Enable option of OpenVPN serv
ice was duplicated (appearing under Remote
Access Control and OpenVPN General Setup).

Corrected: Unable to offer correct networ
k routing to OpenVPN client, except mask

Corrected: Unable to create IPsec LAN
to LAN through central VPN management.

Corrected: Unable to manage VigorAP920R, AP910C and AP902 by central AP

Corrected: IPsec multiple SA tunnels were unstable.

Corrected: After downgrading to v1.3.3.2,
Vigor router would upgrade to v1.4.0

Corrected: IPsec VPN locked up.

Corrected: Web content filter (WCF) for youth
protection driven by BPjM did not work.

Corrected: Failed to route LAN p
ackets through DHCP relay over WAN.

Corrected: WAN Bridge VLAN did not work.

Corrected: Syslog showed 'Apply failed' if por
t redirection included more than one port

Corrected: IPSec VPN was unstable when ne
twork subnet mask was configured as 32.

Corrected: The web content filter for
Youth Protection (BPj
M) did not work.

Corrected: A pop-up message of “File System
Verify failed” appeared when logging web
user interface.

Corrected: If disabling “packet-triggered” of VPN IPsec LAN to LAN profile, such
profile could not reconnect the network
connection after WAN down and WAN up again.

Corrected: Unable to route WAN DHCP conn
ection when the given subnet mask was 32.

Corrected: An IPsec remote dial-in user fail
ed to build VPN connection (with VPN client
behind NAT, and IPsec profile config
ured with static remote host).

Corrected: Unable to start AP management. An
error message of “ap
md crash, do restart!”
appeared on System Maintenance>
>Syslog/Mail Alert>>Syslog File.

Corrected: Data Flow Monitor might
cause Vigor router reboot randomly.

Corrected: USB Thermometer was not de
tected in some configurations.
Known Issue

RD NO: 107_9_12
ps:急件請直接電洽 04-2260-5121 / 0963-685-121
Telegram 頻道 Channel 韌體更新發佈
台中 LINE 商店街 : 技術客服 LINE
文章: 6086
註冊時間: 週五 12月 8日, 2006年 11:10 am
來自: 台中
送出感謝: 16
擁有感謝: 0 次

回到 Draytek 軔體更新討論區


正在瀏覽這個版面的使用者:沒有註冊會員 和 5 位訪客