1
Release Note for Vigor3900 Series
Firmware Version:
1.4.1
Release Type:
Normal
Applied Models:
Vigor3900
Due to the firmware size limitation, for devices us
ing firmware version 1.0.5 or earlier, it is
suggested to upgrade to firmware version 1.0.7.1 firs
t before upgrading to version 1.0.8.x and later.
New Features
Support VigorSwitch P2280/G2280 to be mana
ged under Central Management>>Switch.
Improvement
Corrected: Unable to restore backup
configuration file taken by VigorACS.
Corrected: SNMP service stopped working for
a period of time and recovered again.
Corrected: Enable option of OpenVPN serv
ice was duplicated (appearing under Remote
Access Control and OpenVPN General Setup).
Corrected: Unable to offer correct networ
k routing to OpenVPN client, except mask
“/24”.
Corrected: Unable to create IPsec LAN
to LAN through central VPN management.
Corrected: Unable to manage VigorAP920R, AP910C and AP902 by central AP
management.
Corrected: IPsec multiple SA tunnels were unstable.
Corrected: After downgrading to v1.3.3.2,
Vigor router would upgrade to v1.4.0
automatically.
Corrected: IPsec VPN locked up.
Corrected: Web content filter (WCF) for youth
protection driven by BPjM did not work.
Corrected: Failed to route LAN p
ackets through DHCP relay over WAN.
Corrected: WAN Bridge VLAN did not work.
Corrected: Syslog showed 'Apply failed' if por
t redirection included more than one port
setting.
Corrected: IPSec VPN was unstable when ne
twork subnet mask was configured as 32.
Corrected: The web content filter for
Youth Protection (BPj
M) did not work.
Corrected: A pop-up message of “File System
Verify failed” appeared when logging web
user interface.
Corrected: If disabling “packet-triggered” of VPN IPsec LAN to LAN profile, such
profile could not reconnect the network
connection after WAN down and WAN up again.
Corrected: Unable to route WAN DHCP conn
ection when the given subnet mask was 32.
2
Corrected: An IPsec remote dial-in user fail
ed to build VPN connection (with VPN client
behind NAT, and IPsec profile config
ured with static remote host).
Corrected: Unable to start AP management. An
error message of “ap
md crash, do restart!”
appeared on System Maintenance>
>Syslog/Mail Alert>>Syslog File.
Corrected: Data Flow Monitor might
cause Vigor router reboot randomly.
Corrected: USB Thermometer was not de
tected in some configurations.
Known Issue
None.
RD NO: 107_9_12