1 頁 (共 1 頁)

VigorAP810 v1.2.3.1 Release Note

文章發表於 : 週二 12月 26日, 2017年 11:50 am
門神
- 1 -
Release Note for VigorAP 810
Firmware Version: 1.2.3.1
Release Type: Normal
Applied Models: VigorAP 810
With this high cost-efficiency VigorAP 810, computers and wireless devices which are compatible
with 802.11n can connect to existing wired Ethernet network via this VigorAP 810, at the speed of
300Mbps. Easy install procedures allows users to setup a network environment in very short time -
within minutes, even inexperienced users. Just follow the instructions given in this user manual, you
can complete the setup procedure and release the power of this access point all by yourself!
New Features
None.
Improvement
Improved: A wireless vulnerability, known as 'KRACK' was discovered in October 2017.
This affected wireless clients, including phones, tablets, laptops and also any wireless
base acting as a client.
For full details, see https://www.krackattacks.com. The recommended action in all cases
is to upgrade your client devices as that is where the vulnerability lies however if that is
impossible because the product is too old or the vendor does not provide updates, it is
possible to mitigate KRACK exploitation by disabling EAPOL-Key retries on the base
station and reduce the possibility of KRACK being used. For more details, see
https://www.krackattacks.com/#ap-mitigations. That can be done from "Wireless LAN >>
Security Settings" on the access point. Upgrading your client is still the preferable
solution.
Known Issue
None.
Notes
None.
- 2 -
RD NO: 106_11_21