1 頁 (共 1 頁)

VigorAP 910C v1.2.3.1 2017-11-02

文章發表於 : 週一 11月 6日, 2017年 12:00 pm
門神
VigorAP 910C v1.2.3.1 2017-11-02
- 1 -
Release Note for VigorAP 910C
Firmware Version: 1.2.3.1
Release Type: Normal
Applied Models: VigorAP 910C
VigorAP 910C is a ceiling mount Access Point with PoE for offering power supply and support
300Mbps @2.4GHz, and 866Mbps @5GHz (11ac).
New Features
None.
Improvement
Corrected: WPA2 KRACK vulnerability issue which affected Universal Repeater mode
only. This issue affects all wireless clients so you should check your laptops, phones and
all other wireless clients to see if they need updated software/firmware. Search for
"WPA2 KRACK" with your vendor. See
https://www.draytek.com/en/news/news/20 ... erability/
Improved: Support for TLSv1.2.
Improved: Increase "Wireless LAN (5GHz)" >> "Access Control" list entries up to 256.
Improved: WiFi isolation behavior.
Improved: Support data compression / decompression for AP management.
Improved: Add "Test Inform" button for testing VigorACS connection.
Improved: Add wizard for filling out ACS settings.
Corrected: TCP port 49152 responded to NMAP port scanning.
Corrected: ACS parameter for Roaming was malfunctioning.
(InternetGatewayDevice.X_00507F_WirelessLAN_AP.Roaming.APAClientRoaming.Min
BasicRate)
Corrected: AP CPU usage was always “0” on VigorACS.
Corrected: Minimum RSSI Roaming didn't work.
Corrected: A space appeared after the parameter value of TotalSendByte /
TotalReceiveByte that Vigor CPE replied to VigorACS.
- 2 -
Known Issue
None.
Notes
To enhance the security among wireless clients, the SSIDs on the different bands (2.4GHz
/ 5GHz) will be isolated. That is, wireless clients with different bands can not
communicate with each others even they are on the same subnet.
RD NO: 106_10_30