1 頁 (共 1 頁)

VigorAP910C v1.2.1 Release Note

文章發表於 : 週一 8月 7日, 2017年 3:48 pm
門神
- 1 -
Release Note for VigorAP 910C
Firmware Version: 1.2.1
Release Type: Normal
Applied Models: VigorAP 910C
VigorAP 910C is a ceiling mount Access Point with PoE for offering power supply and support
300Mbps @2.4GHz, and 866Mbps @5GHz (11ac).
New Features
Add TR-069 parameters required by VigorACS 2.0.2.
Add a new option for disabling wireless connection automatically if there is no Internet
access.
Add 5G SSID isolation support.
Improvement
Improved: Web firmware upgrade sporadically failed issue can now be detected and
prevented by guiding user with extra WUI warnings and buttons.
Improved: Add more parameters for wireless traffic statistics.
Improved: Improve the mechanism and the layout for "System Maintenance >>
Configuration Backup" WUI.
Improved: Configure 5G TX power via APM is now supported.
Improved: Device Name in System Maintenance>>Management can now be set with
longer than 15 characters.
Corrected: APM (AP Management) could not connect to AP910C when using
WPA2/802.1x Security Mode.
Corrected: Data Flow Monitor WUI might get stuck issue.
Corrected: Wireless driver related bug fixed.
Known Issue
Firmware version 1.2.0 may cause firmware upgrade failure while upgrading firmware
from web user interface. When meeting firmware upgrade failure, please reboot VigorAP
910C and use Firmware Upgrade Utility to perform the firmware upgrade by a PC
connected to LAN port of VigorAP 910C.
- 2 -
Notes
None
RD NO: 106_07_14