- 1 -
Release Note for VigorAP 910C
Firmware Version: 1.1.5.1
Release Date: September 07, 2015
Applied Models:
VigorAP 910C
VigorAP 910C is a ceiling mount Access Point with PoE for offering power supply and support
300Mbps @2.4GHz, and 866Mbps @5GHz (11ac).
New Features
Support dynamic frequency selection (DFS) channels for wireless 5G.
Improvement
Improved: Device Name can be displayed on System Status page.
Improved: A warning message will appear before AP reboots if the HTTP/HTTPS port
number is changed.
Corrected: TR-069 CPE Username and Password were grayed-out.
Improved: Remove Autoselect for channel selection in Wireless LAN (2.4GHz/5GHz)
>> Universal Repeater.
Corrected: Data information (configured in Quick Start Wizard) for VigorAP could not be
shown correctly on Access Point List after scanned by AP Discovery.
Improved: VigorAP support parameters related to Central AP Management for VigorACS
(based on TR-069).
Corrected: Traffic Graphs drew by daily and weekly are inconsistent.
Improved: Modified the warning message as “The Security and Peer MAC Address of
index 1 must be set earlier than index 2.” while configuring Wireless LAN>>General
Setup for WLAN 2.4G AP Bridge-Point to Multi-Point mode.
Corrected: Display error for Rx Rate value in Wireless LAN (2.4G/5GHz)>>Station
List.
Known Issue
None
- 2 -
Notes
Modifications
None
Bug Lists
None