Vigor3200系列 v3.6.8.2 Release
發表於 : 週三 6月 10日, 2015年 10:17 am- 1 -
NO:AP1101-2 V.1
Release Note for Vigor3200 Series
Firmware Version: 3.6.8.2
Release Date: May 18, 2015
Applied Models:
Vigor3200/Vigor3200n
Vigor3200 Series is a broadband router with multi-WAN feature. It integrates IP layer QoS, and
NAT session/bandwidth management to help users control works well with large bandwidth.
By adopting hardware-based VPN platform and hardware encryption of AES/DES/3DES, the router
increases the performance of VPN greatly, and offers several protocols (such as IPSec/PPTP/L2TP)
with up to 64 VPN tunnels.
New Features
None.
Improvement
Corrected: Firewall session control was invalid and caused that users could not access
into Internet.
Corrected: User management was invalid if User-based mode was activated.
Known Issue
None
Notes
If the firmware of the router is upgraded from 3.6.6(or before) to 3.6.7 firmware, “.all”
and “.rst” will have different effects for the incoming packets.
1) .all --> keep routing configuration in 3.6.6 (or before), (both IPv4 and IPv6).
2) .rst --> block routing packets from WAN in default, (both IPv4 and IPv6).
NO:AP1101-2 V.1
Release Note for Vigor3200 Series
Firmware Version: 3.6.8.2
Release Date: May 18, 2015
Applied Models:
Vigor3200/Vigor3200n
Vigor3200 Series is a broadband router with multi-WAN feature. It integrates IP layer QoS, and
NAT session/bandwidth management to help users control works well with large bandwidth.
By adopting hardware-based VPN platform and hardware encryption of AES/DES/3DES, the router
increases the performance of VPN greatly, and offers several protocols (such as IPSec/PPTP/L2TP)
with up to 64 VPN tunnels.
New Features
None.
Improvement
Corrected: Firewall session control was invalid and caused that users could not access
into Internet.
Corrected: User management was invalid if User-based mode was activated.
Known Issue
None
Notes
If the firmware of the router is upgraded from 3.6.6(or before) to 3.6.7 firmware, “.all”
and “.rst” will have different effects for the incoming packets.
1) .all --> keep routing configuration in 3.6.6 (or before), (both IPv4 and IPv6).
2) .rst --> block routing packets from WAN in default, (both IPv4 and IPv6).