VigorAP800 v1.1.5 Release Note
發表於 : 週四 1月 29日, 2015年 8:58 am- 1 -
Release Note for VigorAP 800
Firmware Version: 1.1.5
Release Date: December 22, 2014
Applied Models: VigorAP 800
"With this high cost-efficiency VigorAP 800, computers and wireless devices which are compatible
with 802.11n can connect to the existing Ethernet network via this VigorAP800. 300Mbps wireless
transmission rates is ideal for bandwidth-heavy tasks. Easy install procedures allow any computer
users to setup a network environment in very short time - within minutes, even inexperienced
users."
New Features
None.
Improvement
Corrected: After enabling Bandwidth Management for Wireless LAN 5G, only the upload
limit setting is available. The download limit did not work.
Corrected: Wireless LAN 5G Security settings configured in Quick Start Wizard did not
work.
Corrected: When Station-Infrastructure was chosen for Wireless LAN( 2.4G), WPA
Algorithms for Wireless LAN(5G)>>Security could not configured and saved
successfully. Hence, the value for Key Renewal Interval was shown as “undefined”.
Corrected: Fixed the burn-in problem.
Corrected: The configuration files for Enable DHCP Client in LAN>>General Setup
between the old firmware version and the new firmware version are not compatible.
Corrected: The fields design for Upload Limit and Download Limit in Wireless
LAN>>Bandwidth Management were reverse.
Corrected: Non-existed channel setting (configured in Central AP
Management>>WLAN Profile of Vigor router) would be shown on System
Maintenance>>System Status on VigorAP800.
Improved: Enhanced for SSLv3 Fallback protection.
- 2 -
Known Issue
None
Notes
Modifications
None
Release Note for VigorAP 800
Firmware Version: 1.1.5
Release Date: December 22, 2014
Applied Models: VigorAP 800
"With this high cost-efficiency VigorAP 800, computers and wireless devices which are compatible
with 802.11n can connect to the existing Ethernet network via this VigorAP800. 300Mbps wireless
transmission rates is ideal for bandwidth-heavy tasks. Easy install procedures allow any computer
users to setup a network environment in very short time - within minutes, even inexperienced
users."
New Features
None.
Improvement
Corrected: After enabling Bandwidth Management for Wireless LAN 5G, only the upload
limit setting is available. The download limit did not work.
Corrected: Wireless LAN 5G Security settings configured in Quick Start Wizard did not
work.
Corrected: When Station-Infrastructure was chosen for Wireless LAN( 2.4G), WPA
Algorithms for Wireless LAN(5G)>>Security could not configured and saved
successfully. Hence, the value for Key Renewal Interval was shown as “undefined”.
Corrected: Fixed the burn-in problem.
Corrected: The configuration files for Enable DHCP Client in LAN>>General Setup
between the old firmware version and the new firmware version are not compatible.
Corrected: The fields design for Upload Limit and Download Limit in Wireless
LAN>>Bandwidth Management were reverse.
Corrected: Non-existed channel setting (configured in Central AP
Management>>WLAN Profile of Vigor router) would be shown on System
Maintenance>>System Status on VigorAP800.
Improved: Enhanced for SSLv3 Fallback protection.
- 2 -
Known Issue
None
Notes
Modifications
None