UBLink技術團隊討論區

VigorAP900 v1.1.3 release

- 1 -
Release Note for VigorAP 900
Firmware Version: 1.1.3
Release Date: April 10, 2014
Applied Models:
VigorAP 900
VigorAP 900, the concurrent dual band wireless (2.4G/5G) access point, offers high-speed data
transmission. With this high cost-efficiency VigorAP 900, computers and wireless devices which
are compatible with 802.11n/802.11a can connect to existing wired Ethernet network via this
VigorAP 900, at the speed of 300Mbps. Easy install procedure allows users to setup a network
environment in very short time - within minutes, even inexperienced users. Also, VigorAP900 is a
Power over Ethernet Powered Device which adopts the technology of PoE for offering power
supply and transmitting data through the Ethernet cable.
New Features
 Support USB temperature sensor.
 Support AP device name displayed for external device client.
Improvement
 Improved: A "hello" message would be sent to iPad on UDP port "5353" every 5 Seconds
to keep Wi-Fi radio alive.
 Improved: Change Router Name into Device Name for Universal Repeater operation
mode.
 Corrected: The status of AP would be shown as “Offline” when the Universal Repeater
was selected as the Operation Mode.
 Corrected: Firmware upgrade failure occurred if it was performed through VigorACS SI.
 Corrected: Could not authenticate any wireless user if VigorAP900 was up / down by
schedule.
 Corrected: Could not get IP address from some router’s DHCP server.
 Corrected: Wireless access control for 5GHz did not work after reboot the device.
Known Issue
 None
- 2 -
Notes
Modifications
 None
Bug Lists
 None