VigorAP900 v1.1.3 release
- 1 -
Release Note for VigorAP 900
Firmware Version: 1.1.3
Release Date: April 10, 2014
Applied Models:
VigorAP 900
VigorAP 900, the concurrent dual band wireless (2.4G/5G) access point, offers high-speed data
transmission. With this high cost-efficiency VigorAP 900, computers and wireless devices which
are compatible with 802.11n/802.11a can connect to existing wired Ethernet network via this
VigorAP 900, at the speed of 300Mbps. Easy install procedure allows users to setup a network
environment in very short time - within minutes, even inexperienced users. Also, VigorAP900 is a
Power over Ethernet Powered Device which adopts the technology of PoE for offering power
supply and transmitting data through the Ethernet cable.
New Features
Support USB temperature sensor.
Support AP device name displayed for external device client.
Improvement
Improved: A "hello" message would be sent to iPad on UDP port "5353" every 5 Seconds
to keep Wi-Fi radio alive.
Improved: Change Router Name into Device Name for Universal Repeater operation
mode.
Corrected: The status of AP would be shown as “Offline” when the Universal Repeater
was selected as the Operation Mode.
Corrected: Firmware upgrade failure occurred if it was performed through VigorACS SI.
Corrected: Could not authenticate any wireless user if VigorAP900 was up / down by
schedule.
Corrected: Could not get IP address from some router’s DHCP server.
Corrected: Wireless access control for 5GHz did not work after reboot the device.
Known Issue
None
- 2 -
Notes
Modifications
None
Bug Lists
None